J
Jack Klarich
Guest
Think I now understand the nose replaced the points. So just to get this straight. I remove plates 2 & 4, and also #5 gasket. I LEAVE the sensor plate attached along with the connector wire.
Start the bike cold, and hit the sensor plate w/dryer and see if it breaks down.
I assume the heat will transfer "through" the plate?
And how long do you guess this should take? A few min or as in a ride, 15-30 min?
I understand where you are at Paul. When I was 26 years old, I only had 1 thing on my mind also..
Try 52 almost 53. Had a long life, and don't want to go back. LOL
Time will tell if this is the problem area , be patient, I know how hard that sounds:s