Bike is 04 Ultra Classic. While riding I starting getting “bus Er and security key light” coming on but bike would crank and run without any issues that I could tell. I tried getting the codes from speedo but the bus Er code keeps it from going into the diagnostic screen. I checked all connections, fuses, switches and even pulled the battery. I couldn’t get it to clear or reset. I figured the TSSM was the issue and decided to replace it with an OEM TSM. I printed out the instructions for the password learn procedure and the first thing it says to do is
Set run switch to run
Turn ign switch on-off, on-off, on-off, on then toggle left turn signal twice
Turn ign switch off-on and verify check eng light and security light come on briefly then turn off
That’s where I’m getting hung up. The lights are not coming on at this point, just the bus Er code still showing up.
The next step is to crank the bike, which it does and shuts off, which is expected, then the check eng light comes on and few seconds later the security light lights up. Which is to happen according to the instructions. It then tells me to leave it on for 10 minutes and when security light goes off, turn ign switch off-on and security light again comes on, wait another 10 minutes ...... etc.
Security light don’t go off. I even tried the procedure several more times turning it off-on just to try and security light doesn’t come back on after the initial time.
I purchased an online manual and found the procedure and it does not say to toggle switch and turn signal switch. Have I gotten it into some setup mode that’s keeping me from completing the TSM setup?
I’m about to pull my hair out over this one, please help.
Thanks
Set run switch to run
Turn ign switch on-off, on-off, on-off, on then toggle left turn signal twice
Turn ign switch off-on and verify check eng light and security light come on briefly then turn off
That’s where I’m getting hung up. The lights are not coming on at this point, just the bus Er code still showing up.
The next step is to crank the bike, which it does and shuts off, which is expected, then the check eng light comes on and few seconds later the security light lights up. Which is to happen according to the instructions. It then tells me to leave it on for 10 minutes and when security light goes off, turn ign switch off-on and security light again comes on, wait another 10 minutes ...... etc.
Security light don’t go off. I even tried the procedure several more times turning it off-on just to try and security light doesn’t come back on after the initial time.
I purchased an online manual and found the procedure and it does not say to toggle switch and turn signal switch. Have I gotten it into some setup mode that’s keeping me from completing the TSM setup?
I’m about to pull my hair out over this one, please help.
Thanks