Ok last bit of Assembly done.. now when it warms up ill fire it up check for exhaust leaks and put the shields on
Here is the little bugger that caused the Delay
Pic of the cylinder with Gasket out
now gasket in
Then the header pipe do not tighten at this time just put in place and finger tighten down the flange nuts
Now to fix up the left side pipe .. if you look closely its out of round they really reef down when tighting this clamp .. the kit comes with another small pipe they call a mandrel but hey its a piece of pipe you hammer in to true up the pipe .. coat the mandrel in wd-40 goes in easier .
Install the now trued up pipe Do not tighten down
Now install the slip on
Start tightening down your clamps tighten the trans mount clamp last after tighting this nut down
That is the old pic the new one you need a swivel socket to tighten it down and ya can't really see it
Tighten this clamp last its the one that holds the stud that mounts to the trans
And there is the True Dual Kit not hard to do if your interested in doing it .
Little bit harder when its around 15 degrees for the whole install
Hopefully it might help someone
Here is the little bugger that caused the Delay
Pic of the cylinder with Gasket out
now gasket in
Then the header pipe do not tighten at this time just put in place and finger tighten down the flange nuts
Now to fix up the left side pipe .. if you look closely its out of round they really reef down when tighting this clamp .. the kit comes with another small pipe they call a mandrel but hey its a piece of pipe you hammer in to true up the pipe .. coat the mandrel in wd-40 goes in easier .
Install the now trued up pipe Do not tighten down
Now install the slip on
Start tightening down your clamps tighten the trans mount clamp last after tighting this nut down
That is the old pic the new one you need a swivel socket to tighten it down and ya can't really see it
Tighten this clamp last its the one that holds the stud that mounts to the trans
And there is the True Dual Kit not hard to do if your interested in doing it .
Little bit harder when its around 15 degrees for the whole install
Hopefully it might help someone
Last edited by a moderator:
