Hello,
My name is Pawel, I'm from Poland, new here.
I have problems with clutch in my 1998 heritage softail.
Very difficult to find neutral, even with little rev up.
very easy if engine off.
I have hydraulic clutch kit.
Throwout bearing is OK, changed friction plates and metal plates to Barnett ones.
Changed oil with 3 different ones, HD Primary, 10w40 motorcycle oil, redline MTL, without success, I adjusted clutch with no turn out, 1/2 turn aot, one turn out, still no help.
I can very easy rotate inner hub with fingers when clutch is pulled.
Very easy shifting when bike is not running, oil in tranny is shockproof heavy, was before 75w90 synthetic. still this same.
Also I checkek for notches on hubs, no one is there.
i also tried to remove damper spring from clutch due all performance clutches doesn't have them, still no help.
I also use m6 hayden tensioner, but still with no luck.
Fluid levels are ok, no overfill.
Primary chain seems to be tensioned same in every position when rotating engine/clutch.
One think I've seen, when plates are removed, if I rotate inner hub, outer seems to not rotating center,looks like it rotating not centered or so,
I checked then tranny mainshaft, but is has no freeplay, and is centered. I've seen this same on friends twincam, but he had no problem with neutral.
last think that i haven't checked is bearing in outer hub (bike has 30k miles).
it was very easy to find out neutral till i burned plates due hydraulic clutch fluid went out, since this time changing everythink, with no luck.
Please give some advice,
Greetings
Pawel.
My name is Pawel, I'm from Poland, new here.
I have problems with clutch in my 1998 heritage softail.
Very difficult to find neutral, even with little rev up.
very easy if engine off.
I have hydraulic clutch kit.
Throwout bearing is OK, changed friction plates and metal plates to Barnett ones.
Changed oil with 3 different ones, HD Primary, 10w40 motorcycle oil, redline MTL, without success, I adjusted clutch with no turn out, 1/2 turn aot, one turn out, still no help.
I can very easy rotate inner hub with fingers when clutch is pulled.
Very easy shifting when bike is not running, oil in tranny is shockproof heavy, was before 75w90 synthetic. still this same.
Also I checkek for notches on hubs, no one is there.
i also tried to remove damper spring from clutch due all performance clutches doesn't have them, still no help.
I also use m6 hayden tensioner, but still with no luck.
Fluid levels are ok, no overfill.
Primary chain seems to be tensioned same in every position when rotating engine/clutch.
One think I've seen, when plates are removed, if I rotate inner hub, outer seems to not rotating center,looks like it rotating not centered or so,
I checked then tranny mainshaft, but is has no freeplay, and is centered. I've seen this same on friends twincam, but he had no problem with neutral.
last think that i haven't checked is bearing in outer hub (bike has 30k miles).
it was very easy to find out neutral till i burned plates due hydraulic clutch fluid went out, since this time changing everythink, with no luck.
Please give some advice,
Greetings
Pawel.