J
Jack Klarich
Guest
I have sealed bearings without race. wheel bearing sets tight against the inner spacer and the puller cannot get a grip. oh its a slide puller.
thanks kemo, thought the heat would work just didn't know bout the wheel, didn't want to ruin one by being stupid. ask before applying flame.
you may have to use a shop press and be very careful how you jig it to get that stubborn gearing out if not you may try a threaded rod and double nuts with a heavy washer the same diameter as the bearing. On the other side of the wheel a piece of pipe large enough for the bearing to pass into, washers and nut, begin tightening nuts until bearing pulls thru into the pipe, you have made a puller and it will work. I have pulled many bearings and bushings this way, Good Luck:s