08xl1200c
I dropped it thursday night after running over concrete median,, dont ask. Anyhow it was slow speed as I hit brakes to avoid, front wheel hit median and bike stopped on top as it went over on left side. I did not go down just bike. Picked up bike and it went over the other way, no damage other than pipe scratches, very minor.
Damge was minor. left rear turn signal scratched and loose, Kuryakian highway bar scratched, chrome rear axle cover damaged. When i put it on jack i found front wheel bearing was bad which i suspected prior to this happening. I replaced bearing and replaced the other cosmetic stuff though not needed and now am finding a vibration. Similar to rear belt needing to be tightened but I checked it and it appears to be within spec. Checked primary chain and it was also fine. at 60 i put my hand on the lower part of forks and no vibraiton so not tire. Handle bars vibrate without holding on or loose holding, re grip and it goes away. Motor mounts look fine. Vibration with heavy acceleration and at certain speeds, some speeds constant but are smooth. (similar agan to drive belt) will ck it again i guess.
Any chance there is internal damage to forks, I am doubting it but no experience with this. Fork oil is 10w amsoil. been there 6months or so.
Also odd that bearing was bad at 18k. right bearing very loose and left seemed ok. changed both. Noticed rust coming from right bearing a couple of weeks ago so guess water instusion.
I dropped it thursday night after running over concrete median,, dont ask. Anyhow it was slow speed as I hit brakes to avoid, front wheel hit median and bike stopped on top as it went over on left side. I did not go down just bike. Picked up bike and it went over the other way, no damage other than pipe scratches, very minor.
Damge was minor. left rear turn signal scratched and loose, Kuryakian highway bar scratched, chrome rear axle cover damaged. When i put it on jack i found front wheel bearing was bad which i suspected prior to this happening. I replaced bearing and replaced the other cosmetic stuff though not needed and now am finding a vibration. Similar to rear belt needing to be tightened but I checked it and it appears to be within spec. Checked primary chain and it was also fine. at 60 i put my hand on the lower part of forks and no vibraiton so not tire. Handle bars vibrate without holding on or loose holding, re grip and it goes away. Motor mounts look fine. Vibration with heavy acceleration and at certain speeds, some speeds constant but are smooth. (similar agan to drive belt) will ck it again i guess.
Any chance there is internal damage to forks, I am doubting it but no experience with this. Fork oil is 10w amsoil. been there 6months or so.
Also odd that bearing was bad at 18k. right bearing very loose and left seemed ok. changed both. Noticed rust coming from right bearing a couple of weeks ago so guess water instusion.