Mavagrand
Senior Member
On the way home from church, check engine light flashed on then off. got home and I had historical codes stored. Checked them, they're as follows:
TSM - b0563 - High voltage (p/n 68924-07 TSSM)
SP - b1006 - Accesory overload
b1007 - ign overload (p/n 67348-04c and 67349-08 Speedo)
T- b1006- Acc overload
b1007 - ign overload
Bike is an 08 FLHTC with Stage 1 and Rhinehart 2 into 1. has 35k on the clock. runs fine, never hesitated when the light flashed. I replaced the Voltage regulator a couple of years ago and have no problems since.
of interest, the rubber boot on my trip reset switch was cracked and allowed water into the switch, it now sticks and I have to push it repeatedly to get it to work. I'm wondering if this switch might be prompting these codes? I have the diagnostic manual and will look more into this on the weekend but wanted to get ya'll's opinion about the reset switch. thanx
TSM - b0563 - High voltage (p/n 68924-07 TSSM)
SP - b1006 - Accesory overload
b1007 - ign overload (p/n 67348-04c and 67349-08 Speedo)
T- b1006- Acc overload
b1007 - ign overload
Bike is an 08 FLHTC with Stage 1 and Rhinehart 2 into 1. has 35k on the clock. runs fine, never hesitated when the light flashed. I replaced the Voltage regulator a couple of years ago and have no problems since.
of interest, the rubber boot on my trip reset switch was cracked and allowed water into the switch, it now sticks and I have to push it repeatedly to get it to work. I'm wondering if this switch might be prompting these codes? I have the diagnostic manual and will look more into this on the weekend but wanted to get ya'll's opinion about the reset switch. thanx