I just bought an ultra calassic 2006 and have been riding it for a couple of days now.I did not get a key fob with this bike and i purchased one from the dealer friday.Today I tried to retreive the pin from the system(i did not get one and probably wont be able to either)I could never get it to show the code after doing the on off on off on then left turn signal twice then the right once oin never came up on the odometer so i decided to ride some.I rode around 20 miles with one short stop and bike started and ran fine.I got home and parked the bike for a while and relaxed.Later i decided to change the oil in the bike so i went into the shop and cranked the bike and let it run at idle while i was getting tools and oil together it ran no longer that a few monutes and just died.I tried to restart and it wouldnt crank so went ahead with the oil change .When i finished the oil i tried to start the bike and it did crank but seemed to be running on one cylinder.I cut the engine off and pu;;ed the plugs to check fire.I did not see any fire at all so i put my finger over the spark plug hole on the front and seem to have great compression then i tried the back and none or very little.I then pulled the pushrod covers off and they were not loose and turning the engine over they are moving up and down.I know this was lengthly but i need help please.
Mark
Mark