how to perform static timing on 98 softail custom 1340 evo

Discussion in 'Electrical' started by hdfozz, Feb 26, 2011.

  1. hdfozz

    hdfozz Member

    Just replaced the cam sensor on evo,scribed mark on inner nose cone and replaced sensor in same position,performed steps per harley service not have the jumper harnesss that the manual calls for..backed probed the gr/wht wire + and - grd. have 5.7 volts constant,does not change when rotating sensor plate,to 1.0 volt as per the manual....I'm checking this with the engine off ignition on, is this the correct way or am I missing something....I did bring the front cyl up to tdc...any info would be very helpful thanks
  2. Jack Klarich

    Jack Klarich Guest

    Harley Ignitions - Harley Davidson Community will this help?