Do you have the right tool to do it? They are sealed wheel bearings that are press fit into the hub... You can "hammer" them out but I don't like "hammering" them back in, it's best to press them in with the proper installer... Take care... T
In the past i have used some threaded bar appropriate sized socket and some big washers to draw the bearings into a wheel
Brian
Just curious....why did you have to replace the bearings? Doesn't seem like an 07 should need new bearings yet.
Ok..........now you guys got my curiosity up. My 2007 FLSTC just turned over 32000 miles. Original wheel bearings front and rear. Never used a water hose of any kind on it. How do you check to see if they need replaced? No wobble when on the lift.
Thanks Jack, that's what I do, wasn't sure if there was more I should check for. I'll be changing oli again in the next few days will listen/feel them again.