I just replace the tire on my 07 Ultra. The brake drag seem excesssive. Is there a proper alignment for the front wheel replacement that may have not been done?
The brakes where not changed. Torq the axle nut to 50 ft lbs and then tightned the lower fork nuts. Is there another way? Is there a brake bleeding guide posted on the forum?
The brakes where not changed. Torq the axle nut to 50 ft lbs and then tightned the lower fork nuts. Is there another way? Is there a brake bleeding guide posted on the forum?
Always check out the appropriate section of the self help forum first.
Best to bounce the front end up and down real hard with the wheel against the wall, then tighten the two slider bolts after that. It keeps the sliders in plane with each other and the front end will work better. You can do it by just loosening up the two slider axle retaining bolts and do the bounce thing then.