I have a 2009 Dyna Low Rider with stock headers and Rush 1.75 slip-ons. While chasing an exhaust leak I replaced the Interconnect Gasket (65830-03) in the crossover pipe. In the 2009 Dyna Models Service Manual (99481-09) under EXHAUST SYSTEM 4.17 under ASSEMBLY: ALL BUT FXDF (page 4-35) Step 2 states: Insert new interconnect gasket (5) into crossover pipe bell on rear exhaust pipe (9). Connect rear exhaust pipe to front exhaust pipe (43) at crossover pipe. My questions: 1) How far down into the crossover pipe bell does the interconnect gasket need to go? 2) How tight is the crossover pipe connection after assembly but before you install it on to bike? 3) Any tips/tricks to ensure the gasket is set correctly? Thank you.