Scrounger Active Member Mar 30, 2012 #11 What ended up working well was a 1 1/2" union piece that I sanded down so one end would fit nicely in the fork lower. I then used the longer 2" piece to go over the fork tube so I could tap the bushing and then seal in. Worked very good.
What ended up working well was a 1 1/2" union piece that I sanded down so one end would fit nicely in the fork lower. I then used the longer 2" piece to go over the fork tube so I could tap the bushing and then seal in. Worked very good.
