I posted this over in another forum, but wanted to share with this community as well. I'd been waffling over cams all winter for my 07 RK police. I'd been looking at all the possible bolt-in, stage II type cams. At one point, I had a set of SE255's in my toolbox ready to go in, but I had a nagging doubt about the 103 motors making too much compression (9.7:1) for these cams. Finally, I took the advice of a couple of builders I trust and put in a set of SE204's, along with the SE high ratio rockers (1.725:1).
I got the bike back together yesterday afternoon, and the little I've ridden so far indicates the cam selection is a winner for these motors. The bike pulls hard right off idle, and keeps on the cam for quite a bit longer than the SE255's would. Nice mild lope at idle as well.
It's a very nice little cam, and with the high ratio rockers makes a good bolt-in for Police/Limited 103 motors.
I got the bike back together yesterday afternoon, and the little I've ridden so far indicates the cam selection is a winner for these motors. The bike pulls hard right off idle, and keeps on the cam for quite a bit longer than the SE255's would. Nice mild lope at idle as well.
It's a very nice little cam, and with the high ratio rockers makes a good bolt-in for Police/Limited 103 motors.