ok here we go, go an 02 fatboy, 6k, with no add-ons cept harley installed tach/speedo.
bike was running on warm up and just stopped.
no power anywhere cept to odometer.
called harley and a few shops, NADA
i am a TECH, so i did my own search..... i found the prob, but still have an issue!
3 wires on ig switch,red w/blk strip on end is melted..
no more ig switch.
ok so i use jumper from red center and on UNPLUGGGED melted red/blk and start bike, ok cool, put reader on, and before ing scan is done the red/blk wire startes to cook some more....
w/out reader on (too $$$$ to lose) i do the same process and still starts to melt...
DONT KNOW WHERE TO GO NOW.
never been down, all stock except as stated at top....
anyone have a clue as to whats up?
pj:34:
REALLY HOPING SOMEONE CAN ANSWER THIS, as its gonna be a nice day here in socal on sat n sunday, would like to ride...
bike was running on warm up and just stopped.
no power anywhere cept to odometer.
called harley and a few shops, NADA
i am a TECH, so i did my own search..... i found the prob, but still have an issue!
3 wires on ig switch,red w/blk strip on end is melted..
no more ig switch.
ok so i use jumper from red center and on UNPLUGGGED melted red/blk and start bike, ok cool, put reader on, and before ing scan is done the red/blk wire startes to cook some more....
w/out reader on (too $$$$ to lose) i do the same process and still starts to melt...
DONT KNOW WHERE TO GO NOW.
never been down, all stock except as stated at top....
anyone have a clue as to whats up?
pj:34:
REALLY HOPING SOMEONE CAN ANSWER THIS, as its gonna be a nice day here in socal on sat n sunday, would like to ride...
Last edited by a moderator: