Hoople
Account Removed
Extra important info you need to know.
You will find that the ECM connector is male pins on the ECM side and female sockets on the wiring harness side. The male pins are part of a complete connector and not available individually.
Therefore you must make your own.
The pins used on that Delphi connector are exactly .040" in diameter. Go to a Hobby shop and buy a length of solid Brass rod that is .040". Make up a few test leads like the attachment shows. Slightly round off the leading edge of probe tip so it enters the receptacle without scraping. You don't want a sharp edge scraping off the gold plating inside the female connector of the wiring harness.
Test leads like these are a must to have. Don't leave home without them.
The pins and sockets on all the end devices (injectors, map sensor, TPS, etc) are different and are available from the dealership. The ECM female connectors are at the dealership also,, it's just the male side that are not.
You will find that the ECM connector is male pins on the ECM side and female sockets on the wiring harness side. The male pins are part of a complete connector and not available individually.
Therefore you must make your own.
The pins used on that Delphi connector are exactly .040" in diameter. Go to a Hobby shop and buy a length of solid Brass rod that is .040". Make up a few test leads like the attachment shows. Slightly round off the leading edge of probe tip so it enters the receptacle without scraping. You don't want a sharp edge scraping off the gold plating inside the female connector of the wiring harness.
Test leads like these are a must to have. Don't leave home without them.
The pins and sockets on all the end devices (injectors, map sensor, TPS, etc) are different and are available from the dealership. The ECM female connectors are at the dealership also,, it's just the male side that are not.