Hey everyone. My 2013 Blackline had bags and tail light relocation when I bought it. Have since sold the bags, removed the pegs, and am trying to figure out how to get the tail lights reinstalled back to the factory position on the fender struts. I've purchased the standoffs for both sides, but not sure how they orient, and the holes through the struts do not go all the way through the fender, so unsure how the wires route. Can anyone help out here?
Stand Off and Tail Light Wiring
- Thread starter cv2065
- Start date
Breeze3at
Experienced Member
Look your bike up on the attached link. The parts diagram should help. http://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
Thanks Bud! I've seen these diagram previously. Doesn't really show how the wire feeds from the tail light itself, through the standoff/strut and then under the fender, as there is no hole to feed through into the fender. I would have to believe that the wire is not feeding underneath the fender where it can be seen?