Power Commander Fuel Map, Help!

[NYHarley]

Ok, so I have a Power Commander on my 2007 Night Train, and I have received two different suggestions from Dynojet regarding what Map to use. I am running a screamin eagle filter kit and Rinehart 2 into 2 Racing Exhaust w/ Baffles installed. I was told by Dynojet to use either of the maps below, but my concern is the fuel maps are quite different. I know this is a base mark, but I want to use something close until I can get some dyno time:

Map - M813-039
2007 Harley Davidson Softail *Advanced Map*
Bub 2:2 7 system Exhaust
Screamin' Eagle air filter
Stock ECM
Rev Xtend enabled
Fuel table 1 is rear cylinder

Map - M813-007
2007 Harley Davidson Softail models
Rinehart 2:2 full exhaust
Screamin' Eagle Air filter
Stock ECM
Dynojet O2 sensor eliminators installed
Rev Xtend enabled

 

[TripleJ]

I agree with Hobbit on the Map - M813-007 but would add to try both and see how your bike responds to both. Doing so will not do any harm.

I am running the Rinehart Crossbacks on my 08 Heritage and did not like the performance with any of the maps I tried for the Crossbacks and ending up using a map for the Vance and Hines True Duals and it made a huge difference in performance.

Good luck!