I was hoping they would have something. I am calling in the AM, am also hoping it is flat with no leads comming out of either end, I would like to have as few splices and crimps as possible, just a plug in system. I can only hope.
You can get just the pin connectors and reuse the end fittings after you release the pins from them. Use a new wire and you are all set. The pins should be in stock.
It's a little trick to release the pins from the sockets, but using a safety pin straightened out to act as a probe it can be done.
There's diagrams in the electrical section of the self help forum to show you how to release them.