free website stats program check enigine light 2009 xl1200n | Harley Davidson Forums

check enigine light 2009 xl1200n

smitty61

Member
i just put a stage 1 air filter and power commander with respective map on my nightster and now my check engine light comes on as i turn the switch then goes off as it should, but after about 2 seconds it comes back on and stays on. i start the bike and it runs a little rough till it warms up then it sounds fine but the check engine light is on. i also did all the work my self. is there something i did wrong or is this something that the dealer would have had to clear the codes or??? thanks for the help!
 
how do i do that?

how do i do that?

never mind dumb question:D

i went through the steps of clearing and the check engine light is still on i has a fault code od P0118 (ET Sensor High) and a pn of: 32152-07A
 
Last edited by a moderator:
The part number is nothing to be concerned about. Check the wiring on the engine temp sensor on the rear of the front head.
 
Back
Top