Iceman24
Well-Known Member
1. Kit includes Plasma Rods (2), dual controller modules (2), wiring harness(1). Added parts to mount on fascia = 8” ¾ PVC corner round molding (2) & roll of auto adhesive tape.

2. Rods & PVC corner round cut to length (8”).

3. Auto molding adhesive applied to rounded surfaces on PVC molding.

4. Rods mounted to PVC molding & diagram (another member design). Ensure curve side matches rear fascia surface(s) (definite Left/Right w/wires @ top).

5. Rear lighting wire harness location is under seat (09 FLHX).


2. Rods & PVC corner round cut to length (8”).

3. Auto molding adhesive applied to rounded surfaces on PVC molding.

4. Rods mounted to PVC molding & diagram (another member design). Ensure curve side matches rear fascia surface(s) (definite Left/Right w/wires @ top).

5. Rear lighting wire harness location is under seat (09 FLHX).
