Passing Lamp Aiming

[zoood]

I'm having trouble keeping the assembly aligned as I get to the torque spec. Any tips or suggestions?:cry

Go to this link I just started - Passing lamp adjustment - Harley Davidson Community

 

[glaxo1]

Will a flare nut wrench (crowfoot) work also? The only place I have found the flare nut sockets is Snap-On and I'm sure you know how expensive those are. I found some in Britain but they only come in metric. Imagine that. lol. Can any machine shop make me a socket if I take one in to them?

Thanks. I'm learning a lot from this forum. I appreciate everyone sharing their knowledge.

 

[zoood]

Will a flare nut wrench (crowfoot) work also? The only place I have found the flare nut sockets is Snap-On and I'm sure you know how expensive those are. I found some in Britain but they only come in metric. Imagine that. lol. Can any machine shop make me a socket if I take one in to them?

Thanks. I'm learning a lot from this forum. I appreciate everyone sharing their knowledge.

Jack in here said that the flare nut wrench will work. I used a 9/16" deep socket and slit the side wall with a wiz wheel. That works for me.

zoood/RJ

 

[glider]

Jack in here said that the flare nut wrench will work. I used a 9/16" deep socket and slit the side wall with a wiz wheel. That works for me.

zoood/RJ

The slit socket works best so you don't round out any fasteners.

It doesn't have to be fancy either, just functional.