H hildeberto ortiz New Member Feb 8, 2021 #1 The rotor does not come out all the way to replace the stator any help please?
R Roadking-1960 Active Member Feb 9, 2021 #2 According to my manual , two bolts should be inserted in the holes in the rotorface. Now you can pull the rotorface off equally. Good luck !!. start watching at 8 min. Attachments upload_2021-2-9_9-56-15.png 57.8 KB · Views: 5 upload_2021-2-9_9-57-1.png 75.7 KB · Views: 5
According to my manual , two bolts should be inserted in the holes in the rotorface. Now you can pull the rotorface off equally. Good luck !!. start watching at 8 min.
Blue Wide Glide Junior Member Feb 13, 2021 #4 Magnetic force is holding it in, there is no physical connection. Pay lots of attention to the routing of the wiring from the stator, no room for error!
Magnetic force is holding it in, there is no physical connection. Pay lots of attention to the routing of the wiring from the stator, no room for error!
L LENNY HARE New Member May 22, 2022 #5 hildeberto ortiz said: The rotor does not come out all the way to replace the stator any help please? Click to expand... I'm having the same problem, almost looks like the inner primary has to come off. I see this was a while back, how did it go?? Last edited by a moderator: May 23, 2022
hildeberto ortiz said: The rotor does not come out all the way to replace the stator any help please? Click to expand... I'm having the same problem, almost looks like the inner primary has to come off. I see this was a while back, how did it go??